India customer come in person to check the machine produced for him

This customer came from India, he bought a door frame machine from us.

This is a small machine, without decoiler and cutter and receiving table.

The only part of this machine is the main roll forming machine.

At first this machine finish time is a little delay, customer not happy.

But after he visited us, he said his afraid mind was calm down.

He said our machine quality is better than the other factories.

Here I attached our machine parameters for you check.

Size of the main part: about 3200х 800х 1500mm
Weight of main part: 2.5 tons
Voltage: 415 v 50 hz 3 phase
Frame type: Middle plate weld
Transmission mode: By gear
Material of rollers: Cr12mov
Material of shafts: 45# steel with tempering
Diameter of shafts: φ 40 mm
Number of rollers: 15 rollers
Forming speed: 8-10m per minutes
Transmission motor power: 3 kw
Processing material thickness: 0.5mm